Clavia Nord Modular V3 Manuel d'utilisateur télécharger pdf (Page 133)

NORD MODULAR V3.0 7. Module reference: LFO group

Page 125

The clock generator module generates a stream of logic signals. The module can also act as a master to

slave LFOs.

The Clock generator is not dependant on any MIDI clock signals, but acts on its own. If

you want to sync to MIDI clock, you must instead use the Clock output of the ‘MIDI Global’ module

described on

page 95

The yellow Reset input forces the clock generator to restart each time it receives a signal that changes from

0 units or below to anything above 0 units. This signal could come from a gate output of a Keyboard or

Sequencer module, for example. When the clock generator is reset, it transmits a high logic signal on the

Sync output.

A gray slave signal output for controlling the rate of slave LFOs. If the ratio of the slave LFO is set to 1:1,

1 BPM on the clock generator module corresponds to 1 Hz on the slave LFO. Patch this output to a Mst

input on a slave LFO.

Displays the rate in beats per minute, BPM. Range: 24 to 214 BPM.

Set the desired rate, in beats per minute, with the knob. Range: 24 to 214 BPM.

/O/O

Starts and stops the generation of clock pulses.

24 24

This yellow output transmits 24 clock pulses for each quarter note.

Signal:

Logic

4 4

This yellow output transmits 4 clock pulses for each quarter note.

Signal:

Logic

This yellow output transmits a high logic signal when the generator is reset or started.

Signal:

Logic

1 2 ... 128 129 130 131 132 133 134 135 136 137 138 ... 231 232

Pas de commentaire

Clavia Nord Modular V3 Manuel d'utilisateur Page 133