Clavia Nord Lead 3 Manuel d'utilisateur télécharger pdf (Page 28)

Page 28 Programming Velocity Sensitivity

Morphing

Morphing is a term used to describe a continuous blend or “transfer” between two images, sounds or sim-

ilar. As described above, the Velocity/Morph function in Nord Lead 2 is normally controlled by velocity.

But you can route the function to the modulation wheel instead which allows you to continuously fade

between two sounds – morphing!

The only thing you have to do to activate morphing for a sound that’s already set up for velocity control

is to press the Mod Wheel destination button until Morph is the only lit indicator:

However, if you are setting up a Morph sound from scratch, we recommend the following procedure:

1. Press the Mod Wheel destination button until only the Morph indicator is lit.

2. Make sure the Modulation wheel is all the way down.

3. Set up the basic Program as you want it.

4. Move the Modulation wheel all the way up.

5. Press Velocity/Morph button and adjust the knobs so that the Program sounds the way you want it at “the

other end” of the Morph.

6. Press Velocity/Morph again.

7. Play and move the Mod Wheel to try out the effect.

You can also use an Expression pedal for Morphing, see page 18.

Please note that the Velocity function in the Filter section can be used even if Morphing is active, so that

a Program can be basically Velocity sensitive even though Morphing is activated.

SHIFT

FILTER

OSC 2

MORPH

LFO 1

Push this button... ...until only the Morph LED is lit.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 113 114

Pas de commentaire

Clavia Nord Lead 3 Manuel d'utilisateur Page 28